AuthorDamzie ArchivesCategories |
Back to Blog
N1mm logger tricks2/25/2022 Here’s a couple photos of the pre-assembled interface for the G-1000DXA that connects directly to the 6 Pin DIN on the back of the controller.Īnd here is a photo of the parts for the G-450A controller laid out for inventory before assembly. #N1mm logger tricks softwareI didn’t get a picture of the ERC packaging, but they are put together nicely in a resealable bag with all necessary parts and instructions and software on a CD. Lots of bending protection and the rotor inserts are small enough to fit in the smallest PO Box without folding the envelope. This will give you plenty of replacements and a couple extra so you can be the club hero when a friend needs a replacement.ĬQMaps does a great job packaging their items. They cost nearly nothing, so it makes sense to order a dozen even if you only need one. I already had bulbs that I had purchased in the past. Configure interfaces for both N1MM and DXLabs logging software. #N1mm logger tricks installBuild and install computer interface in the G-450A and plug in interface for G-1000DXA.Move map insert from G-450A to G-1000DXA and add new insert into G-450A.It did fit, but needed some adjustments, so I left it in until James had finished coming up with the new version for the G-450A. I had also previously purchased the rotor map insert for the G1000DXA, but had installed it in the G-450A as a test for James, N4EGA CQMaps to help him determine if he needed to create a different version for each controller model. If you’ve never opened up a Yaesu controller to replace a bulb, the process can be somewhat of a pain, but I’ve opened up both of these boxes to do repairs in the past, and after the first time, it becomes much easier. Now that Vibroplex was carrying them, ordering would be simple and when I went to Dayton last May, I picked up an interface for each of the controllers. A year or so ago I had looked into ordering one directly from ERC, but didn’t want to deal with international shipping. Lucky for me, Scott, W4PA, announced just before Dayton that Vibroplex is now the US distributor for Easy-Rotor-Control (ERC), a German company making a rotor interface that I’d heard good things about. I had previously looked into the interface sold by Idiom Press (now ), but they had received some negative feedback regarding their customer service before they sold their company and they only had an interface for the G-1000DXA. I had also been on the lookout for a low-cost computer interface that would allow me to adjust the controller’s azimuthal angle directly from the logging software instead of reaching over to push and hold down the switches on the face of the box. Both of the boxes needed their hard-wired bulbs replaced (I prefer the soft glow of an incandescent bulb over the available LED mods) and I needed to add the rotor maps that I had purchased from CQMaps. The other is a G-450A, which was originally purchased for the Hexbeam, but now turns the 40-2CD that goes up on an AB-577 tower during contest season. The first is a Yaesu G-1000DXA that I bought used from Jack, W1WEF, and is installed on the tower under the Hexbeam. Currently the station here has two rotors and controllers. A project that had been on my shack’s list of things to do for quite some time was to replace the burned out bulbs in my rotor controllers and apply a couple upgrades while I had them open.
0 Comments
Read More
Leave a Reply. |